Diamante V6-2972cc 3.0L SOHC (1992)
Variable Induction Control Actuator: Testing and Inspection
Variable Induction Control Motor
Engine Control Module Connector--For Pin Applications See Components
To test the Variable Induction Control Servo (VICS) DC motor located on the intake manifold, proceed as follows.
1.
Disconnect the VICS harness connector.
Variable Induction Control Servo, Continuity Test Hook-up
2.
Using an ohm meter, check the resistance between component connector terminals 1 and 2.
Resistance
5 - 35 Ohms 68°F (20°C)