Diamante V6-2972cc 3.0L SOHC (1992)
Ignition Control Module: Testing and Inspection
Power Transistor
NOTE: An analog-type circuit tester should be used.
Ignition Power Transistor Continuity Check
1. Connect the negative (-) terminal of the 1.5 V power supply to terminal (2) of the ignition power transistor; then check whether there is continuity
between terminal (3) and terminal (2) when terminal (1) and the positive (+) terminal are connected and disconnected.
NOTE: Connect (-) Probe of the circuit tester to the terminal (3)
Ignition Power Transistor Continuity Check Table
2. Replace the ignition power transistor if there is a malfunction.