Diamante V6-2972cc 3.0L SOHC (1992)
SRS DIagnosis Unit Connectors
5. After disconnecting the battery cable, wait 60 seconds or more before proceeding with the following work. The SRS system is designed to
retain enough voltage to deploy the air bags for a short time even after the battery has been disconnected, so serious injury may result from
unintended air bag deployment if work is done on the SRS system immediately after the battery cables are disconnected.
6. SRS components should not be subjected to heat over 93°C (200°F), so remove the front impact sensor~ SRS diagnosis unit and air bag
module and clock spring before drying or baking the vehicle after painting.
7. Whenever you finish servicing the SRS, check the SRS warning light operation to make sure that the system functions properly.
8. Make certain that the ignition switch is at OFF when the Scan Tool is connected or disconnected.
9. If you have any questions above the SRS. please contact your local distributor.
WARNING: SERIOUS INJURY CAN RESULT FROM UNINTENDED AIR BAG DEPLOYMENT, SO USE ONLY THE
PROCEDURES AND EQUIPMENT SPECIFIED IN THIS MANUAL.
