Diamante V6-2972cc 3.0L SOHC (1992)
(2) Holding the driven bevel gear in a vice and using the special tool, remove the lock nut.
REASSEMBLY SERVICE POINTS
A. SPACER SELECTION
(1) Use the existing spacer to assemble the transfer case adapter.
(2) Using the special tool, check that the bevel gear rotating drive torque is within standard range.
Standard value:
1.0 - 1.7 Nm (0.72-1.23 ft.lbs.)
(3) If the rotating drive torque is outside of the standard range, adjust using adjusting spacers.
B. TAPER ROLLER BEARING INSTALLATION
C. LOCK NUT INSTALLATION
