Diamante Sedan V6-2972cc 3.0L DOHC (1993)
Closed Throttle Position Switch: Adjustments
Without Traction Control
Throttle Position Sensor
1. Disconnect the Throttle Position Sensor (TPS) connector.
Throttle Position Sensor Test
2. Connect an ohmmeter between terminals # 3 (closed throttle position switch) and # 4 Sensor ground), using lead wires with alligator clips.
Throttle Lever Adjustment
3. Insert a 0.65 mm (0.0256 in.) feeler gauge between the Fixed SAS and the throttle lever.
Throttle Position Sensor Adjustment
4. Loosen the TPS mounting bolts, then turn the TPS counterclockwise completely.
-
Continuity should exist at this time.
5. Slowly turn the TPS in a clockwise direction until continuity is broken.
6. Tighten TPS mounting screw.