Diamante Sedan V6-2972cc 3.0L DOHC (1993)
Closed Throttle Position Switch: Adjustments
With Traction Control
With Scan Tool
1.
Connect scan tool to data link connector (white).
2.
Without starting the engine turn the ignition switch to the ON position, and check the TPS output voltage.
Acceptable Voltage
0.580 - 0.690 volts
3.
If the voltage is out of specification, loosen the TPS mounting bolts, and rotate the TPS until the output is within specification.
4.
Tighten TPS mounting bolt.
5.
Turn OFF the ignition switch.
6.
Clear codes and disconnect scan tool.
Without Scan Tool
1.
Connect a voltmeter between terminals # 2 (sensor output) and # 4 (Sensor ground) of the TPS connector (white), (using a test harness that allows
access to all TPS wires).
2.
Without starting the engine turn the ignition switch to the ON position, and check the TPS output voltage.
Acceptable Voltage
0.580 - 0.690 volts
3.
If the voltage is out of specification, loosen the TPS mounting bolts, and rotate the TPS until the output is within specification.
4.
Tighten TPS mounting bolt.
5.
Turn OFF the ignition switch.
6.
Clear codes and remove test harness.
