Diamante Sedan V6-3.5L SOHC (1999)
Disconnect the negative battery cable from the battery and tape the terminal.
CAUTION: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.
2. Remove Footrest
3. Remove Console Side Cover (LH and RH)
4. Remove Floor Carpet Reinforcement (LH and RH)
5. Remove Harness Protector
6. Remove ECM/TCM
7. Remove SRS-ECU
Installation
To Install reverse the Removal steps and note the following.
CAUTION: The SRS may not activate if SRS-ECU is not installed properly, which could result in serious injury or death to the vehicle's driver or front
passenger.
On-Board Diagnostic/SRS Warning Light Function
Post-Installation Inspection
1. Turn the ignition key to the "ON" position.
2. Does the "SRS" warning light illuminate for about 7 seconds, and then remain off for at least 5 seconds after turning off?
3. If yes, SRS system is functioning properly. If no, consult troubleshooting.