Eclipse L4-1996cc 2.0L DOHC (1995)
BLOCK DIAGRAM OF SYSTEM
PROCEDURE
MEMORY PROGRAMMING
1)
Press and hold one of the sun visor unit switches (1, 2, or 3). The LED should flash (one time per second).
NOTE:
If the unit has already been programmed, the LED will illuminate without flashing. To reprogram the unit, see CHANGING MEMORY SETTINGS
on page three of this bulletin.
2)
While still pressing the sun visor unit switch, point the customer's hand-held transmitter at the HomeLink(TM) sun visor unit and activate the
transmitter. The LED flashes rapidly (5-6 times per second) and then the LED will switch off. The signal from the transmitter is now recorded into
the sun visor unit.
CAUTION!
The distance between the transmitter and the sun visor unit must be within 25 mm (1 inch).