Eclipse L4-1996cc 2.0L DOHC (1995)
11.
Inspect the seam to locate any break in the sealant or incomplete coverage of the sheet metal joints. See the indicated area in the illustration. If a
sealant break or void is found, apply sealer (RTV silicone or equivalent) to the seam, shown as the shaded area in the illustration inset. If no void
is identified, reseal the entire seam. The sealant break or void may be too small to be seen.
12.
Water test the seam by spraying water on the outside of the car at the lower right side A-pillar area and along the lower windshield area to make
sure the leak is repaired.
NOTE: Move the ABS controller away from the bulkhead to prevent water damage to the controller in case the sealing procedures in Step 11
were insufficient.
13.
After you are sure the water leak is repaired, reinstall all removed components in reverse order of removal.
14.
For all air conditioned vehicles, refer to the service manual and recharge the system.
Warranty Information
Nature Code: 727
Cause Code: 200
Vehicles Without Air Conditioning:
Labor Operation Number: 42102395
Time Allowance: 2.5 hrs.
Vehicles With Air Conditioning:
Labor Operation Number: 42102396
Time Allowance: 3.5 hrs.
(includes A/C recharge)
Warranty Coverage: Basic 3 years/36,000 miles
Special Warranty Information: On an as needed basis only.