Eclipse L4-1996cc 2.0L DOHC (1995)
Technical Service Bulletin # 9542A004
Date: 950501
Door Glass - Wind Noise/Water Leaks
NO. TSB-95-42A-004
DATE: May, 1995
MODEL: 1995 Eclipse
SUBJECT:
DOOR GLASS ADJUSTMENT
BACKGROUND INFORMATION
Improper door glass adjustment may cause wind and water leakage, difficult window operation, and/or damaged drip molding. There are four glass
positions that can be adjusted. Adjusting one of these glass positions may affect the other three positions.
PARALLELISM - If the parallelism is set incorrectly, there will be an unequal gap at the quarter glass molding. Adjusting the equalizer arm (window
regulator) bracket changes this glass position.
FORE AND AFT - Fore and aft refers to the front-to-rear glass position. Adjusting the glass guide rear track slotted screws changes the fore and aft
position of the glass.
HEIGHT - Adjusting the up-stops changes the maximum height to which the glass rises when rolled completely up.
TILT - Tilt is the inboard-outboard position of the upper corner of the glass. Adjusting the glass guide rear track slotted screws changes the tilt.
This Technical Service Bulletin is divided into three sections:
^
Measurements and Specifications
^
Symptom Chart
^
Adjustment Procedures
To use this Technical Service Bulletin:
1.
Make glass measurements as described in the MEASUREMENTS AND SPECIFICATIONS section to determine which position is out of
specification.
2.
Using these measurements and the SYMPTOM CHART, determine which adjustment procedure is required.
3.
Refer to the ADJUSTMENT PROCEDURES section for instructions. Remember that adjusting one glass position may affect the other positions,
so always reverify measurements and specifications.
VEHICLES AFFECTED: 1995 Eclipse
WARRANTY INFORMATION
Door Glass Adjustments (One or All) (One Side)
