Eclipse L4-1996cc 20L DOHC (1995) - ABS Light: Brakes- ABS Lamp ON/Multiple DTC's Set
7.
Remove the corrugated tubing from the harness in the area of the splice shown above. Then remove the black tape wrapped around the harness to
access the red/black wire splice located about six inches from the A-23 connector.
8.
Inspect for corrosion at the splice joint. If there is corrosion at the splice, remove the corroded portion.
Regardless of presence of corrosion, solder the wires, using the preferred method:
a.
Insert the stripped ends of the wires into a split brass tube (solder splice) if available, and crimp the wire ends together, making a good
mechanical joint.