Eclipse L4-1997cc 2.0L DOHC (1991)
NOTE: Install new camshafts using the following procedure.
1. Remove the rocker arms.
2. Lay the camshafts on the cylinder head and install the bearing caps.
3. Check that the camshaft can be easily turned by hand.
4. After checking, remove the bearing caps and the camshafts. and install the rocker arms.
2. The camshaft's dowel pins should be at the positions shown in the figure.
17./16./15./14.
INSTALLATION OF CAMSHAFT BEARING CAPS
Tighten the bearing cap installation bolts to the specified torque in two or three steps.
CAUTION: Tighten uniformly, otherwise the rocker arms will not be straight.
13. INSTALLATION OF CAMSHAFT OIL SEALS
Using the special tool, press in the oil seal as shown in the figure.
10. INSTALLATION OF THE CRANKSHAFT ANGLE SENSOR