Eclipse L4-1997cc 2.0L DOHC (1991)
8. REMOVAL OF FELT
Using a flat-tip (-) screwdriver, remove the felt from the front housing.
11. REMOVAL OF SHAFT SEAL
Using a flat-tip (-) screwdriver, remove the shaft seal from the front housing.
INSPECTION
-
Check the surface of the clutch hub for scoring or bluing.
-
Check the surface of the rotor for scoring or bluing.
-
Check the sealing surfaces for cracks, scratches and deformation.
-
Check the front housing for cracks or scoring on the sealing surfaces.
-
Check the compressor shaft for scoring.
SERVICE POINTS OF REASSEMBLY
11. INSTALLATION OF SHAFT SEAL
(1) Lubricate the shaft seal with specified compressor oil.
Specified compressor oil: DENSO OIL 6 or SUNISO 5G5
(2) Set the shaft seal to the front housing so that the projection side of the center ring is at the shaft seal side.
(3) Using a 21 mm (.83 in.) socket, install the shaft seal.
7. INSTALLATION OF FRONT HOUSING