Eclipse L4-1997cc 2.0L DOHC (1991)
Idle Speed: Testing and Inspection
CURB IDLE SPEED TESTING AND INSPECTION
(1) The vehicle should be prepared as follows before the inspection
-
Engine coolant temperature: 85-95°C (185-205°F)
-
Lights, electric cooling fan and accessories: OFF
-
Transaxle: Neutral ("P" for vehicles with an automatic transaxle)
(2) Connect a tachometer.
-
Insert a paper clip (from the harness side) into the 1-pin connector shown in the figure.
-
Connect a primary-Voltage-detection type of tachometer to the paper clip.
Tachometer Connector Usage
Caution: The paper clip should be inserted between the terminals as shown in the figure above.
NOTE: For rpm, one-half of the actual engine rpm is indicated, so the actual engine rpm is two times the indicated value shown by the tachometer.
-
Use a jumper wire to ground the diagnostic test mode control terminal of the data link connector.