Eclipse L4-1997cc 2.0L DOHC (1991)
Lower Control Arm: Service and Repair
Lower Control Arm & Ball Joint
1.
Raise and support vehicle, then remove front wheels.
2.
Disconnect stabilizer bar from lower control arm.
3.
Loosen ball joint stud nut, then disconnect ball joint from knuckle using a suitable tool.
4.
Remove lower control arm from crossmember.
5.
Inspect control arm and bushings, replacing as necessary.
6.
Check ball joint starting torque. Starting torque should be 17-78 inch lbs. Replace ball joint as required.
7.
Check ball joint dust cover for cracks and damage. If necessary, remove defective dust cover and replace with new cover using tool No.
MB990800 or equivalent.
8.
Reverse procedure to install.
