Eclipse L4-1997cc 2.0L DOHC (1991)
Rear Knuckle: Service and Repair
Removal/Installation
1.
Raise and support vehicle, then remove front wheels.
2.
Disconnect brake caliper assembly and support using suitable wire.
3.
Disconnect lower control arm ball joint from knuckle using a suitable tool.
4.
Remove stabilizer bar from lower control arm.
5.
Disconnect tie rod end from knuckle using a suitable tool.
6.
Remove driveshaft from hub.
7.
Remove hub and knuckle as an assembly from strut assembly.
8.
Reverse procedure to install.