Eclipse L4-1997cc 2.0L DOHC Turbo 16 Valve (1996)
c. Check that the camshaft can be easily turned by hand.
d. After checking, remove the bearing caps and the camshafts, and install the rocker arms.
4. The camshafts dowel pins sold be at the positions shown in the figure.
5. In two or three steps, tighten the bearing cap bolts to 19 - 21 Nm (14 - 15 ft. lbs.).
CAUTION: Tighten uniformly, otherwise the rocker arms will not be straight.
6. Use the camshaft oil seal installer tool No. MB998713, or equivalent, to drive the camshaft oil seal into position carefully.
7. Install the camshaft position sensing cylinder to the end of the camshaft as shown in the illustration.
8. Install the camshaft position sensor support.