Eclipse L4-2.4L SOHC (2004)
MMNA recommends using the following PPG products, or their equivalent, for this procedure:
PPG SU4901 - Clean and Scuff Sponge
PPG SU4902 - Plastic Adhesion Wipe
PPG SU4903 - Advanced Plastic
Bond
(or SUA4903 aerosol version)
1.
Using PPG SU 4901 Clean and Scuff Sponge or equivalent, clean the fascia thoroughly with the pre-saturated sponge and rinse well with water.
Blow dry or wipe dry with a clean cloth. Be sure that the surface is dry, without water spots, before continuing this procedure. Refer to the
manufacturer's instructions provided with the product.
2.
If the fascia has any noticeable scratches or other minor surface defects, sand the affected area using P600 grit or finer sandpaper.
a.
After sanding, clean the affected area with PPG SXA 103 Multi-Prep or equivalent. Refer to the manufacturer's instructions provided with
the product.
3.
Using PPG SU4902 Plastic Adhesion or equivalent, apply a light, even coat over the entire surface, wiping in one direction to minimize overlap.
Allow 3 to 5 minutes before continuing.
4.
Apply a light coat of PPG SU4903 or equivalent over the entire surface, covering all edges thoroughly. Allow 3 to 5 minutes before applying paint
.
