Eclipse L4-2.4L SOHC (2004)
2. Measure the resistance value between terminal 2 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 6.
NO: Go to Step 4.
STEP 4. Check front combination light (LH) connector A-26 for damage.
Q: Is front combination light (LH) connector A-26 in good condition?
YES: Go to Step 5.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the turn-signal lights illuminate normally.
STEP 5. Check the wiring harness between front combination light (LH) connector A-26 (terminal 2) and ground.
Q: Is the wiring harness between front combination light (LH) connector A-26 (terminal 2) and ground in good condition?
YES: Replace the front combination light socket (LH). Check that the turn-signal lights illuminate normally.
NO: Repair the wiring harness. Check that the turn-signal lights illuminate normally.