Eclipse L4-2.4L SOHC (2004)
STEP 15. Check the wiring harness between power window relay connector C-116 (terminal 4) and power window main switch connector E-12
(terminal 6).
NOTE: Also check junction block connector C-111 and intermediate connector C-91. If junction block connector C-111 or intermediate connectors
C-91 is damaged, repair or replace the connector as described in Harness Connector Inspection.
Q: Is the wiring harness between power window relay connector C-116 (terminal 4) and power window main switch connector E-12 (terminal 6) in good
condition?
YES: Replace the ETACS-ECU. Check that the power windows work normally.
NO: Repair the wiring harness. Check that the power windows work normally.
Inspection Procedure D-2
Power Window: The Power Window Timer does not Work Normally.
NOTE: This troubleshooting requires use of scan tool MB991958 and SWS monitor kit MB991862. For details of how to use the SWS monitor, refer
to "How to use SWS monitor." See: Reading and Clearing Diagnostic Trouble Codes/How To Use SWS Monitor