Eclipse L4-2.4L SOHC (2004)
wiper motor.
1. Disconnect windshield wiper motor connector A-03, and measure at the wiring harness side.
2. Turn the ignition switch to the "ACC" position.
3. Measure the voltage between terminal 1 and ground.
-
The measured value should be approximately 12 Volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 5.
NO: Go to Step 3.
STEP 3. Check windshield wiper motor connector A-03 for damage.
Q: Is windshield wiper motor connector A-03 in good condition?
YES: Go to Step 4.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the windshield wiper works normally.