Eclipse V6-3.0L SOHC (2003)
2. Align the mating marks on the distributor housing and coupling, then install the distributor to the engine.
>>D<< ROCKER ARM AND SHAFT ASSEMBLY INSTALLATION
1. Rotate the camshaft until the dowel pin on its front end is located as shown in the illustration.
NOTE: Placing the camshaft in the illustrated position minimizes the amount of cam lift, making it easier to install the rocker arm and shaft
assembly.
2. Temporarily tighten the rocker shaft with the bolts so that all rocker arms on the inlet valve side do not push the valves.
3. Position the rocker shaft spring so that it takes a right angle against the plug guide.
NOTE: Set the rocker shaft spring before installing the rocker arm and shaft assembly on the exhaust side.
4. Tighten the rocker arm and shaft assembly mounting bolts to the specified torque.
Tightening torque: 31 ± 3 Nm (23 ± 2 ft. lbs.)
5. Remove special tool MD998443.
