mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2354 > < Initial Inspection and Diagnostic Overview|Page 2352
Page 290
background image

2. Measure the resistance value between terminal 5 and ground.

-

The measured value should be 2 ohm or less.

Q: Does the measured resistance value correspond with this range?

YES: Go to Step 18.

NO: Go to Step 16.

STEP 16. Check rear combination light (LH) connector F-17 for damage.

Q: Is rear combination light (LH) connector F-17 in good condition?

YES: Go to Step 17.

NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the turn-signal lights illuminate normally.

Initial Inspection and Diagnostic Overview|Page 2354 > < Initial Inspection and Diagnostic Overview|Page 2352