Eclipse V6-3.8L (6G75) (2006)
STEP 5. Check the wiring harness between multi-center display unit connector C-06 (terminal 1) and battery.
NOTE: Also check intermediate connector C-24 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If intermediate
connector C-24 is damaged, repair or replace the wiring harness. Refer to Harness Connector Inspection.
Q: Is the wiring harness between multi-center display unit connector C-06 and battery in good condition?
YES: There is no action to be taken.
NO: Repair the wiring harness. The multi-center display unit should work normally.
STEP 6. Check the multi-center display unit power supply circuit [ignition switch (ACC)]. Measure the voltage at the multi-center display unit
connector C-06.
1. Disconnect the multi-center display unit connector C-06 and measure at the harness side.
2. Turn the ignition switch to "ACC" position.
3. Measure the voltage between terminal 3 and ground by backprobing.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts?
YES: Go to Step 8.
NO: Go to Step 7.