Eclipse V6-3.8L (6G75) (2006)
STEP 9. Check the wiring harness between front-ECU connector A-14X (terminal 28) and the ignition switch (ACC).
NOTE: Also check intermediate connector C-24 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If intermediate
connector C-24 is damaged, repair or replace the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between front-ECU connector A-14X (terminal 28) and the ignition switch (ACC) in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the windshield wiper works normally.
Inspection Procedure G-2
INSPECTION PROCEDURE G-2: Windshield Wiper and Washer: The windshield wipers do not work when the windshield wiper switch is at
"INT" or "MIST" position or the windshield washer switch is at "ON" position. However, the wipers work at low speed when the windshield
wiper switch is at "LO" or "HI."
NOTE: This troubleshooting procedure requires use of scan tool MB991958 and SWS monitor kit MB991813. For details on how to use the SWS
monitor, refer to "How to use SWS monitor."