Eclipse V6-3.8L (6G75) (2006)
1. Operate scan tool MB991958 according to the procedure below to display "ETACS ECU."
a. Select "Interactive Diagnosis."
b. Select "System select."
c. Select "SWS."
d. Select "SWS MONITOR."
e. Select "Data List."
f.
Select "ETACS ECU."
2. Check that normal conditions are displayed for the items described in the table.
Q: Does the scan tool MB991958 display the items "IG SW (IG1)", "IG SW (ACC)" and "FRONT DOOR SW" as normal condition?
Normal conditions are displayed for all the items: Go to Step 4.
Normal condition is not displayed for "IG SW (IG1)": Refer to Inspection Procedure M-2 "ETACS-ECU does not receive any signal from the
ignition switch (IG1)."
Normal condition is not displayed for "IG SW (ACC)": Refer to Inspection Procedure M-1 "ETACS-ECU does not receive any signal from the
ignition switch (ACC)."
Normal condition is not displayed for "FRONT DOOR SW": Refer to Inspection Procedure M-5 "ETACS-ECU does not receive any signal from
the door switches."