Eclipse V6-3.8L (6G75) (2006)
STEP 3. Check the wiring harness between ETACS-ECU connector C-217 (terminal 4) and the ignition switch (ACC).
NOTE: Also check intermediate connector C-24 and junction block connector C-203 for loose, corroded, or damaged terminals, or terminals pushed
back in the connector. If intermediate connector C-24 or junction block connector C-203 is damaged, repair or replace the damaged component(s) as
described in Harness Connector Inspection.
Q: Is the wiring harness between ETACS-ECU connector C-217 (terminal 4) and ignition switch (ACC) in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. If the equipment described in "CIRCUIT OPERATION" works normally, the input signal from
the ignition switch (ACC) should be normal.
Inspection Procedure M-2
INSPECTION PROCEDURE M-2: ETACS-ECU does not receive any signal from the ignition switch (IG1).
Ignition Switch (IG1) Input Circuit Part 1