Eclipse V6-3.8L (6G75) (2006)
Remove the door switch (LH). Refer to Door, Door Assembly Then check continuity between the switch terminals and the body ground.
Q: Is the door switch (LH) in good condition?
YES: Go to Step 4.
NO: Replace the door switch (LH). If the functions described in "CIRCUIT OPERATION" work normally, the input signal from the door switch
(LH) should be normal.
STEP 4. Measure resistance at the lower metal part of the door switch (LH) in order to check the ground circuit to the door switch (LH).
NOTE: Check that the door switch (LH) is grounded to the vehicle body via its mounting screw.
Remove the cap, and measure the resistance value between the lower metal part and ground.
-
The resistance should be 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 5.
NO: Check the installation of the switch, and repair if necessary. If the functions described in "CIRCUIT OPERATION" work normally, the input
signal from the door switch (LH) should be normal.