Eclipse V6-3.8L (6G75) (2006)
1. Disconnect door lock actuator (LH) connector E-11 and measure the resistance available at the wiring harness side of the connector.
2. Measure the resistance value between terminal 1 and ground.
-
The resistance should be 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 6.
NO: Go to Step 5.
STEP 5. Check the wiring harness between door lock actuator (LH) connector E-11 (terminal 1) and ground.
NOTE: Also check intermediate connector C-25 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If intermediate
connector C-25 is damaged, repair or replace the connector as described in Harness Connector Inspection.