Eclipse V6-3.8L (6G75) (2006)
2. Use a transmission jack to hold the crossmember, and then remove the crossmember mounting nuts and bolts.
3. Lower the crossmember with the rear roll stopper, the stabilizer bar and the steering gear.
INSTALLATION SERVICE POINTS
>>A<< STABILIZER BAR INSTALLATION
Align the stabilizer bar identification mark with the right end of the bushing (LH).
>>B<< POWER STEERING GEAR BRACKET/ENGINE REAR ROLL STOPPER BRACKET INSTALLATION
Tighten the bolts in the following sequence:
1. Tighten bolt A and then tighten bolt B.
2. Tighten bolts E finger tight.
3. Tighten bolt C and then tighten bolts D.
4. Tighten bolts E and then tighten bolt F.
>>C<< ENGINE REAR ROLL STOPPER BRACKET, POWER STEERING GEAR AND LINKAGE, STABILIZER BAR AND FRONT
AXLE NO.1 CROSSMEMBER ASSEMBLY INSTALLATION
1. Use a transmission jack to lift the crossmember assembly.