Eclipse V6-3.8L (6G75) (2006)
NOTE: The sealant should be applied in a continuous bead approximately 4.0 mm (0.16 inch) in diameter.
4. Assemble the oil pan to the cylinder block within 15 minutes after applying the sealant.
CAUTION: The bolt holes for bolts 13 and 14 in the illustration are cut away on the transaxle side. Be careful not to insert these bolts at an
angle.
5. Tighten the bolts in the order shown in the illustration.
>>B<< ENGINE LOWER OIL PAN INSTALLATION
1. Remove old sealant from the engine lower oil pan and engine upper oil pan.
2. Apply a bead of the sealant to the mating surface of the engine lower oil pan as shown.
Specified sealant: 3M AAD Part No.8672, 8704, 3M AAD Part No.8679/8678 or equivalent
NOTE: Install the engine lower oil pan within 15 minutes after applying sealant.
3. Assemble the engine lower oil pan to the engine upper oil pan.
CAUTION: Then wait at least one hour. Never start the engine or let engine oil or coolant touch the sealant surface during that time.