Eclipse V6-3.8L (6G75) (2006)
2. Disconnect joint connector (3) C-03, and measure the resistance at the wiring harness side of joint connector (3) C-03.
3. Measure the resistance between joint connector (3) terminal 4 (CAN_H) and body ground.
OK: 1 k ohms or more
4. Measure the resistance between joint connector (3) terminal 15 (CAN_L) and body ground.
OK: 1 k ohms or more
CAUTION: Strictly observe the specified wiring harness repair procedure.
Q: Is the check result normal?
YES: Go to Step 4.
NO: Repair the wiring harness between joint connector (3) and the combination meter connector.
STEP 4. Check the CAN line between joint connector (3) and the ETACS-ECU connector for short to ground. Measure the resistance at joint
connector (3) C-03.
CAUTION: Disconnect the negative battery terminal.
1. Disconnect the negative battery terminal.