Eclipse V6-3.8L (6G75) (2006)
/Page-692043.png)
OK: 1 k ohms or more
4. Measure the resistance between ECM <M/T> or PCM <A/T> connector terminal 18 and body ground.
OK: 1 k ohms or more
CAUTION: Strictly observe the specified wiring harness repair procedure.
Q: Is the check result normal?
YES: Go to Step 13.
NO: Repair the wiring harness between ECM <M/T> or PCM <A/T> connector and ABS-ECU <vehicles without traction control system> or
ABS/TCL-ECU <vehicles with traction control system> connector.
STEP 13. Retest the system.
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958.
1. Connect scan tool MB991958 to the data link connector.
2. Diagnose CAN bus lines, and check if scan tool MB991958 screen shows normal state.
Q: Is the check result normal?
YES: Intermittent malfunction.
NO: Check the ABS-ECU <vehicles without traction control system> or ABS/TCL-ECU <vehicles with traction control system> connector, and
repair if necessary. If the ABS-ECU <vehicles without traction control system> or ABS/TCL-ECU <vehicles with traction control system>