Eclipse V6-3.8L (6G75) (2006)
2. Disconnect SRS-ECU connector C-123, and measure the resistance at the component side of SRS-ECU connector C-123.
3. Measure the resistance between SRS-ECU connector terminals 32 and 43.
OK: 1 k ohms or more
Q: Is the check result normal?
YES: Check the SRS-ECU connector, and repair if necessary. If the SRS-ECU connector is in good condition, repair the wiring harness between
joint connector (3) and SRS-ECU connector.
NO: Check the SRS-ECU connector, and repair if necessary. If the SRS-ECU connector is in good condition, replace the SRS-ECU.
STEP 12. Check the ECM <M/T> or PCM <A/T> for short circuit. Measure the resistance at ECM <M/T> or PCM <A/T> connector B-18.
1. Disconnect the negative battery terminal.