Eclipse V6-3.8L (6G75) (2006)
Seat Belt Control Module: Service and Repair
Removal and Installation
SRS CONTROL UNIT (SRS-ECU)
Pre-removal Operation
Removal Steps 1-2
REMOVAL AND INSTALLATION
WARNING:
-
Never attempt to disassemble or repair the SRS-ECU. If faulty, replace it.
-
Do not drop or subject the SRS-ECU to impact or vibration. If denting,cracking, deformation, or rust are discovered in the SRS-ECU,
replace it with a new SRS-ECU.
-
After deployment of an air bag, replace the SRS-ECU with a new one.
-
Never use an ohmmeter on or near the SRS-ECU, and use only the special test equipment described here.
-
When removing and installing the front passenger seat, be sure to carryout accuracy check occupant classification sensor after the seat
has been installed in the vehicle. (On-vehicle Service)
REMOVAL SERVICE POINTS
[A] NEGATIVE (-) BATTERY CABLE DISCONNECTION
DANGER: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.