Eclipse V6-3.8L (6G75) (2006)
2. Use a transmission jack to hold the crossmember, and then remove the crossmember mounting nuts and bolts.
3. Lower the crossmember with the rear roll stopper, the stabilizer bar and the steering gear.
INSTALLATION SERVICE POINTS
>>A<< POWER STEERING GEAR BRACKET/REAR ROLL STOPPER INSTALLATION
Tighten the bolts as follows:
1. Tighten bolt A and then tighten bolt B.
2. Tighten bolts E finger-tight.
3. Tighten bolt C and then tighten bolts D.
4. Tighten bolts E and then tighten bolt F.
>>B<< STABILIZER BAR/STABILIZER BUSHING/STABILIZER BRACKET INSTALLATION
Align the stabilizer bar identification mark with the right end of the bushing (LH).
>>C<< STEERING COLUMN DASH PANEL COVER/CROSSMEMBER ASSEMBLY/PINCH CLAMP INSTALLATION
1. Install the pinch clamp and align the steering column dash panel cover notch (arrow A) with the steering gear lug (arrow B), and then install
the steering column dash panel cover to the steering gear.