Eclipse V6-3.8L (6G75) (2006)
WARNING: Wear goggles when drilling to protect your eyes from flying metal debris.
The gas must be discharged from the strut before discarding it. Place the strut horizontally with its piston rod extended. Then drill a hole of
approximately 3 mm (0.12 inch) in diameter at the location shown in the illustration and discharge the gas.
ASSEMBLY SERVICE POINTS
>>A<< SPRING LOWER PAD INSTALLATION
Engage the three lugs of the spring lower pad into the holes on the front suspension strut as shown.
>>B<< STRUT INSULATOR INSTALLATION
If the upper plate and lower plate of the strut insulator have been disassembled, assemble them as shown.
>>C<< STRUT NUT (SELF-LOCKING NUT) INSTALLATION
1. Ensure that the bearing is seated correctly.
WARNING: When the strut piston rod is positioned to the hole of strut insulator with compressing the coil spring, be careful that your
hand is not jammed by the coil spring.