Eclipse V6-3.8L (6G75) (2006)
5. Use special tool MB990480 to remove the quarter window glass.
CAUTION:
-
Be careful not to remove more adhesive than is necessary.
-
Be careful also not to damage the paint on the body surface with the knife. If the paint is damaged, repair the damaged area with
touch-up paint.
6. Use a knife to cut away the remaining adhesive so that the thickness is within 2 mm (0.08 inch) around the entire circumference of the body
flange.
7. Finish the flange surfaces so that they are smooth.
CAUTION: Allow the cleaned area to dry for at least three minutes. Do not touch any surface that has been cleaned.
8. When reusing the quarter window glass, remove the adhesive still adhering to the quarter window glass, and clean with 3M(TM) AAD Part
number 8880 or equivalent.
9. Clean the body side in the same way.
INSTALLATION SERVICE POINTS
]]A[[ GASKET/CLIP INSTALLATION
Carry out the following procedure to re-install quarter window glass.
CAUTION: Remember to install the gasket.
1. Fit clips into body.
2. Cut away clip fitting convex on quarter window glass.