Eclipse GS L4-2350cc 2.4L SOHC MFI (2002)
1. Use special tools MB990767 and MD998719 to loosen the camshaft sprocket securing bolt.
2. Remove the camshaft sprocket.
<<B>> ROCKER ARM AND SHAFT ASSEMBLY REMOVAL
1. Install special tool MD998443 as shown in the illustration so that the lash adjusters will not fall out.
CAUTION: Never disassemble the rocker arm and shaft assembly.
2. Loosen the rocker arm and shaft assembly mounting bolt, and then remove the rocker arm and shaft assembly with the bolt still attached.
INSTALLATION SERVICE POINTS
>>A<< ROCKER ARM AND SHAFT ASSEMBLY INSTALLATION
1. Temporarily tighten the rocker shaft with the bolt so that all rocker arms do not push the valves.
2. Fit the rocker shaft spring from the above and position it so that it is right angles to the plug guide.
NOTE: Install the rocker shaft spring before installing the rocker arm and rocker arm shaft on the exhaust side.
3. Tighten the rocker arm and shaft assembly mounting bolt to the specified torque.
Tightening torque: 31 ± 3 Nm (23 ± 2 ft. lbs.)
4. Remove special tool MD998443.
