Eclipse GS L4-2350cc 2.4L SOHC MFI (2002)
NOTE: Also check junction block connectors C-101 and C-112 and intermediate connector C-89. If junction block connectors C-101 or C-112 or
intermediate connector C-89 is damaged, repair or replace the connector as described in Harness connector Inspection.
Q: Is the wiring harness between rear combination light (RH) connector F-09 and front-ECU connector A-10X in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. The tail light (RH) and the side marker light (RH) should illuminate normally.
STEP 12. Check the position light bulb (LH).
1. Remove the position light bulb (LH).
2. Check that the position light bulb (LH) is not broken.
Q: Is the position light bulb (LH) in good condition?
YES: Go to Step 13.
NO: Replace the position light bulb (LH). Check that the position light (LH) illuminates normally.
STEP 13. Measure at front combination light (LH) connector A-26 in order to check the ground circuit to the position light (LH).
1. Disconnect front combination light (LH) connector A-26, and measure at the wiring harness side.
2. Measure the resistance value between terminal 2 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 16.
NO: Go to Step 14.
