mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2107 > < Initial Inspection and Diagnostic Overview|Page 2105
Page 181
background image

Q: Are front combination light (LH) connector A-26 and front-ECU connector A-10X in good condition?

YES: Go to Step 17.

NO: Repair or replace the connector. Refer to Harness Connector Inspection. The tail light (LH, incorporated in rear combination light) and the side
marker light (LH) should illuminate normally. Check that the position light (LH) illuminates normally.

STEP 17. Check the wiring harness between front combination light (LH) connector A-26 and front-ECU connector A-10X.

NOTE:  Also check joint connector C-77 and intermediate connector C-89. If joint connector C-77 or intermediate connector C-89 is damaged, repair or
replace the connector as described in Harness connector Inspection.

Q: Is the wiring harness between front combination light (LH) connector A-26 and front-ECU connector A-10X in good condition?

YES: Replace the position light socket (LH). Check that the position light (LH) illuminates normally.

NO: Repair the wiring harness. Check that the position light (LH) illuminates normally.

Initial Inspection and Diagnostic Overview|Page 2107 > < Initial Inspection and Diagnostic Overview|Page 2105