Eclipse GS L4-2350cc 2.4L SOHC MFI (2002)
STEP 13. Check the wiring harness between fog light relay connector A-04X and fog light (RH) connector A-31.
NOTE: Also check intermediate connector C-06. If intermediate connectors C-06 is damaged, repair or replace the connector as described in Harness
Connector Inspection.
Q: Is the wiring harness between fog light relay connector A-04X and fog light (RH) connector A-31 in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. Check that the fog lights illuminate normally.
STEP 14. Check the fog light indicator light bulb.
1. Remove the fog light indicator light bulb.
2. Check that the fog light indicator light bulb is not broken.
Q: Is the fog light indicator light bulb in good condition?
YES: Go to Step 15.
NO: Replace the fog light indicator light bulb. Check that the fog light indicator light illuminates normally.
STEP 15. Measure at combination meter connector C-43 in order to check the ground circuit to the fog light indicator light.
1. Disconnect fog light indicator light connector C-43, and measure at the wiring harness side.
2. Measure the resistance value between terminal 12 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
