mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2213 > < Initial Inspection and Diagnostic Overview|Page 2211
Page 287
background image

NO: Go to Step 5.

STEP 5. Check combination meter connector C-42 for damage.

Q: Is combination meter connector C-42 in good condition?

YES: Go to Step 6.

NO: Repair or replace the connector. Refer to Harness Connector Inspection. The theft-alarm indicator light should illuminate, and the theft-alarm
system should be set normally.

STEP 6. Check the wiring harness between combination meter connector C-42 and the battery.

NOTE:  Also check joint connector C-78 and intermediate connector C-89. If joint connector C-78 or intermediate connectors C-89 is damaged, repair
or replace the connector as described in Harness Connector Inspection.

Q: Is the wiring harness between combination meter connector C-42 and the battery in good condition?

YES: No action to be taken.

NO: Repair the wiring harness. The theft-alarm indicator light should illuminate, and the theft-alarm system should be set normally.

Initial Inspection and Diagnostic Overview|Page 2213 > < Initial Inspection and Diagnostic Overview|Page 2211