Eclipse GS L4-2350cc 2.4L SOHC MFI (2002)
STEP 1. Check the key reminder switch.
Disconnect key reminder switch connector C-88. Then check continuity between terminals.
Q: Is the key reminder switch in good condition?
YES: Go to Step 2.
NO: Replace the key reminder switch. If the functions, which are described in "CIRCUIT OPERATION", work normally, the input signal from the
key reminder switch should be normal.
STEP 2. Measure at key reminder switch connector C-88 in order to the ground circuit to the key reminder switch.
1. Disconnect key reminder switch connector C-88, and measure at the wiring harness side.
2. Measure the resistance value between terminal 4 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 5.
NO: Go to Step 3.
STEP 3. Check key reminder switch connector C-88 for damage.
Q: Is key reminder switch connector C-88 in good condition?
YES: Go to Step 4.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. If the functions, which are described in "CIRCUIT OPERATION",
work normally, the input signal from the key reminder switch should be normal.
