Eclipse GS L4-2350cc 2.4L SOHC MFI (2002)
STEP 5. Check hazard warning light switch connector C-10 and ETACS-ECU connector C-118 for damage.
Q: Are hazard warning light switch connector C-10 and ETACS-ECU connector C-118 in good condition?
YES: Go to Step 6.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. If the equipment, which are described in "CIRCUIT OPERATION",
work normally, the input signal from the hazard warning light switch should be normal.
STEP 6. Check the wiring harness between hazard warning light switch connector C-10 and ETACS-ECU connector C-118.
Q: Is the wiring harness between hazard warning light switch connector C-10 and ETACS-ECU connector C-118 in good condition?
YES: Replace the ETACS-ECU. If the equipment, which are described in "CIRCUIT OPERATION", work normally, the input signal from the hazard
warning light switch should be normal.
NO: Repair the wiring harness. If the equipment, which are described in "CIRCUIT OPERATION", work normally, the input signal from the hazard
warning light switch should be normal.
Inspection Procedure P-3
The ETACS-ECU does not Receive Any Signal from the Driver's Seat Belt Switch.