Eclipse GS L4-2350cc 2.4L SOHC MFI (2002)
When updating the ROM packs for this bulletin, use the passwords shown.
7.
Install the red label interface cartridge to the MUT-II. Then install the 256 KBYTE red memory card and the red label ROM pack. Be sure to use
the ROM pack with the appropriate database number.
8.
Reconnect the MUT-II. Connect both the 16-pin and the 12-pin data link connectors.
9.
Turn the ignition key to ON.
CAUTION
DO NOT DISTURB THE HARNESS CABLES OR CONNECTIONS. INTERRUPTION DURING THE PROGRAMMING PROCESS COULD
CAUSE THE PCM TO LOSE DATA OR PREVENT FUTURE PCM REPROGRAMMING.
10.
For manual transmission models, select "MFI".
For automatic transmission models, select "MFI & ELC-A/T." Then press "YES".
NOTE:
The MUT-II will take a few seconds to verify the ROM-ID.
11.
If the PCM has already been reprogrammed, the MUT-II will display "This ECU has already been reprogrammed. "If this message displays.
STOP! Do not continue with this procedure.
12.
If the PCM is unable to be reprogrammed, the MUT-II will display "Reprogramming is not possible on this ECU." If this message displays, verify
that the correct ROM pack is installed. If the correct ROM pack is installed and this message displays, replace the PCM. Record this MUT-II
screen information and the ROM pack database number on the repair order.
a.
If you replace the PCM, be sure to verify that the new PCM has the latest software. After installing the new PCM, follow the instructions in
Step 3 to read the ECU part number and ROM ID. Then compare this information with the latest PCM software database information on the
Diamond Dealer Link and in MEDIC. Reprogram the new PCM if necessary.
13.
If the PCM can be reprogrammed, the MUT-II will display, "Do you want to reprogram this ECU?" Press "YES".
