Eclipse GT V6-3.0L SOHC (2000)
Tightening torque: 226 ± 29 Nm (167 ± 21 ft. lbs.)
3) Use a spring scale to measure the hub torque in the forward direction. Record bud torque with pads re moved.
CAUTION: Do not let any oil, grease or other contamination get onto the friction surfaces of the pads and brake discs.
2. After re-installing the caliper support to the knuckle, install the pad clips and the pads to the caliper support.
3. Clean the piston and insert into cylinder with special tool MB990520.
4. Be careful that the piston boot does not become caught, when lowering the caliper assembly and installing the guide pin.
5. Check the brake drag force as follows.
1) Start the engine and hold the brake pedal down for 5 seconds. [Pedal depression force: approximately 196 N (44 lbs.)]
2) Stop the engine.
3) Turn the brake disc forward 10 times.
4) Use a spring scale to measure the hub torque with pads installed in the same direction as earlier.
5) Calculate the drag force of the disc brake [difference between hub torque with pads installed and hub torque with pads removed].
6. If the brake drag force exceeds the standard value, disassemble and clean the piston. Check for corrosion or worn piston seal, and check the
sliding condition of the lock pin and guide pin.
INSPECTION BRAKE DISC CHECK
Refer to Testing and Inspection.
