Eclipse GT V6-3.0L SOHC (2000)
STEP 5. Check the harness wires between ETACS-ECU connector C-li 4 and passenger's door lock actuator connector E-07.
NOTE: After checking junction block connector C-104 and intermediate connector C-19, check the wires. If junction block connector C-104 and
intermediate connector C-19 are damaged, repair or replace them. Refer to Harness Connector Inspection.
If the harness wires between ETACS-ECU connector C-114 and passenger's door lock actuator connector E-07 are damaged, repair them.
All doors should be locked or unlocked.
If the harness wires are in good condition, replace the ETACS-ECU.
All doors should be locked or unlocked.
Inspection Procedure C-3
TECHNICAL DESCRIPTION (COMMENT)
The door lock switch (built into the power window switch) or the ETACS-ECU may be defective.
TROUBLESHOOTING HINTS
-
Malfunction of the power window switch (door lock switch)
-
Damaged harness wires or connectors
DIAGNOSIS
Required Special Tools:
MB991223: Test Harness Set
MB991502: Scan Tool (MUT-II)
MB991529: Diagnostic Trouble Code Check Harness
Check the input signal.
Check the input signals from the defective door lock switch.