Eclipse GT V6-3.0L SOHC (2000)
2. Voltage between terminal 3 and ground.
-
Voltage should be approximately 12 volts (battery positive voltage).
If not approximately 12 volts, go to Step 2.
If approximately 12 volts, go to Step 4.
STEP 2. Check the sunroof motor assembly connector D-06 for damage.
If the sunroof motor assembly connector D-06 is damaged, repair or replace it. Refer to Harness Connector Inspection.
The sunroof should work normally.
If the connector is in good condition, go to Step 3.
STEP 3. Check the harness wires between sunroof motor assembly connector D-06 and battery.
NOTE: After checking intermediate connector C-89, joint connector C-78, junction block connector C-103 and C-109, check the wires. If intermediate
connector C-89, joint connector C-78, junction block connector C-103 and C-109 are damaged, repair or replace them. Refer to Harness Connector
Inspection.
If the harness wires between sunroof motor assembly connector D-06 and battery are damaged, repair or replace them.
The sunroof should work normally.