Eclipse GT V6-3.0L SOHC (2000)
<When using scan tool MB991502>
CAUTION: To prevent damage to scan tool MB991502, always turn the ignition switch to "LOCK" (OFF) position before connecting or disconnecting
scan tool MB991502.
1. Connect scan tool MB991502 to the data link connector.
2. Check that the tone alarm of scan tool MB991502 sounds when the input signal enters.
<When using a voltmeter>
1. Use special tool MB991529 to connect a voltmeter between ground terminal 4 or 5 and ETACS-ECU terminal 9 of the data link connector.
2. Check that the voltmeter indicator deflects once when the input signal enters.
If a defect appears, check the windshield wiper switch input circuit. Refer to Inspection Procedure O-18.
If no defect appears, go to Step 2.
STEP 2. Check the windshield wiper motor.
1. Disconnect the wiper motor connector A-03.
2. Connect a battery to the wiper motor as shown in the illustration and check motor operation at low-speed and high-speed.
If the wiper motor is damaged, replace the wiper motor. The windshield wiper should work normally.
If the wiper motor is in good condition, go to Step 3.
